Securing Lock Carrier

Information 

Observe previously made marks on the body and align the lock carrier accordingly.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Tighten screws on carrier to > Tightening torque 55 (41 ftlb.) Nm  .

   Tighten screws on upper part of lock carrier to > Tightening torque 9.7 (7.5 ftlb) Nm  .

   Tighten screws on lock carrier side section to > Tightening torque 9.7 (7.5 ftlb) Nm  .

   Tighten screw for support to > Tightening torque 3.6 (2.6 ftlb.) Nm  .

   Tighten screws for refrigerant line holder to > Tightening torque 4.5 (3.25 ftlb.) Nm  .