| Disc valve holder to transmission |
M6 x 12 |
Tightening torque |
12 Nm (8.9 ftlb.) |
|
|
| Cable duct to transmission |
M10 x 20 |
Tightening torque |
40 Nm (29.5 ftlb.) |
|
|
| Cable duct to transmission |
M6 x 16 |
Tightening torque |
13 Nm (9.6 ftlb.) |
|
|
| Battery positive cable to cable socket on transmission |
Collar nut, M8 |
Tightening torque |
23 Nm (17 ftlb.) |
|
|
| Transmission bracket to body |
Hexagon-head bolt, M10 x 42 |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Transmission bracket to body |
Hexagon-head bolt, M10 x 42 |
Torque angle |
60° |
|
|
| Transmission support to body |
Collar nut, M10 |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Transmission support to body |
Collar nut, M10 |
Torque angle |
60° |
|
|
| Transmission bracket to transmission mount |
Collar nut, M10 |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Transmission bracket to transmission mount |
Collar nut, M10 |
Torque angle |
60° |
|
|
| Transmission flange to engine |
Screw, M12 x 1.5 x 55 - observe specified tightening sequence |
Tightening torque |
85 Nm (62.7 ftlb.) |
|
|
| Drive shaft to transmission flange |
Item 2: Replace cheese head bolt M10 x 46.5 with washer after removal |
Initial tightening |
40 Nm (29.5 ftlb.) |
|
|
| Mounting for drive shaft on transmission flange |
| Drive shaft to transmission flange |
Item 2: Replace cheese head bolt M10 x 46.5 with washer after removal |
Final tightening torque angle |
+ 110° |
|
|
| Mounting for drive shaft on transmission flange |
| Line holder to body |
Screw, M6 x 40 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Line holder |
| Pressure line to distributor |
Cap screw, M14 x 1.5 |
Tightening torque |
28 Nm (21 ftlb.) |
|
|
| Pressure lines to distributor |