Subsequent Work
- All-wheel drive vehicles : Secure the cardan shaft to the double-clutch transmission.
- Install rear axle carrier.
- Secure ground strap for battery.
978509 LOOSENING AND SECURING GROUND STRAP FOR BATTERY
Information
After replacing the Porsche Doppelkupplung (PDK) or after carrying out repairs in the Porsche Doppelkupplung (PDK), the transmission control unit must be calibrated using the PIWIS Tester .
- If the double-clutch transmission was replaced:
- 4.1 Perform calibration:
- 4.1.1 PIWIS Tester -> Transmission/PDK control unit -> Maintenance/repairs -> Calibration of double-clutch transmission > Calibration of transmission after part replacement
- 4.1.2 Read and follow the instructions on the Tester.
- 4.2 Check data version in the transmission electronics control unit and update to the latest data version if necessary.
- 4.1 Perform calibration:
- In the event of significant coolant loss (> 200 ml), drain the coolant and bleed the system.
- Check engine coolant level and fill to maximum level if necessary.
- Vehicles with PDCC: Bleed the PDCC system.