Before Starting Suspension Alignment: Prerequisites

Setpoint values for front and rear axles can be found in the technical data. 

4495TW ADJUSTMENT VALUES FOR SUSPENSION ALIGNMENT 

To exclude erroneous measurements, the following preconditions must be met:

• Empty weight of vehicle according to DIN 70020, i.e. vehicle in ready-to-drive condition with full fuel tank and including tools but without driver or additional weights.
• Joint and wheel-bearing play OK (wheel-bearing play cannot be adjusted). Check joint play if necessary.
• The tread depth on one axle must not differ by more than 2 mm.
• Tyre pressure in accordance with specifications
• Strictly comply with maintenance intervals for measuring equipment and measuring platform.
• Perform suspension alignment only in the sequence specified in the Service Information.