General Information

If a new set of wheels is used or wheel electronics units were replaced, the TPM system must be taught. When teaching the TPM system, the control unit stores the wheel IDs of the wheel electronics units and assigns a position to them.

New wheel electronics units can be taught by selecting a new set of wheels in the instrument cluster. The system is then in learning mode and re-assigns the wheel IDs that are received.

But the system also detects a wheel change if the stored information does not correspond to the information received. The control unit then displays a message on the instrument cluster prompting you to select the newly fitted set of wheels.

The wheel electronics units can be taught while the vehicle is driving and while it is stationary. Teaching while driving is recommended.