| Connecting link (conventional) to rear anti-roll bar |
Collar nut, M10/always replace following removal |
Initial tightening |
40 Nm (29.5 ftlb.) |
|
|
| Connecting link (conventional) to rear anti-roll bar |
Collar nut, M10/always replace following removal |
Final tightening |
+ 30° |
|
|
| Connecting link (conventional) to rear wheel bearing housing |
Hexagon nut, M12/always replace following removal |
Initial tightening |
50 Nm (36.9 ftlb.) |
|
|
| Connecting link (conventional) to rear wheel bearing housing |
Hexagon nut, M12/always replace following removal |
Final tightening |
+ 40° |
|
|