| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always replace following removal |
Initial tightening |
50 Nm (36.9 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always replace following removal |
Final tightening angle |
+ 50 (37 ftlb.) ° |
|
|
| Connecting link (PDCC actuator) to wheel bearing housing |
Cheese head bolt M12 x 1.5 x 72 + hexagon nut/replace after each removal |
Initial tightening |
50 Nm (36.9 ftlb.) |
|
|
| Connecting link (PDCC actuator) to wheel bearing housing |
Cheese head bolt M12 x 1.5 x 72 + hexagon nut/replace after each removal |
Final tightening angle |
+ 50 (37 ftlb.) ° |
|
|
| Hydraulic lines to connecting link (PDCC actuator) |
Banjo bolt, M12 x 1.5 |
Tightening torque |
26 Nm (19.2 ftlb.) |
|
|