| Rear axle carrier to rear axle carrier side section |
M12 x 1.5 x 110 hexagon-head bolt/always replace bolts following removal |
Initial tightening |
70 Nm (51.6 ftlb.) |
|
|
| Rear axle carrier to rear axle carrier side section |
M12 x 1.5 x 110 hexagon-head bolt/always replace bolts following removal |
Final tightening |
+ 180° |
|
|
| Rear axle carrier to rear axle carrier side section |
M12 x 1.5 x 95 hexagon-head bolt/always replace bolts following removal |
Initial tightening |
70 Nm (51.6 ftlb.) |
|
|
| Rear axle carrier to rear axle carrier side section |
M12 x 1.5 x 95 hexagon-head bolt/always replace bolts following removal |
Final tightening |
+ 180° |
|
|
| Connecting link (conventional) to rear anti-roll bar |
Collar nut, M10/always replace following removal |
Initial tightening |
40 Nm (29.5 ftlb.) |
|
|
| Connecting link (conventional) to rear anti-roll bar |
Collar nut, M10/always replace following removal |
Final tightening |
+ 30° |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always replace following removal |
Initial tightening |
50 Nm (36.9 ftlb.) |
|
|
| Connecting link (PDCC actuator) to anti-roll bar |
Collar nut, M12/always replace following removal |
Final tightening angle |
+ 50 (37 ftlb.) ° |
|
|