Loosening Sub-Part For PDK

NOTE: Incorrect handling of main wire harness

Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.

→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.

→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.

Open the right central connector -1- by turning it anti-clockwise -arrow A- and pull it off -arrow B- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Central connector at the right
Open the left central connector -1- by turning it anti-clockwise -arrow A- and pull it off -arrow B- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Central connector at the left
Release and disconnect electric plug connections on sensors -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections
Release electric plug connections, -1- disconnect them and unclip them from the -2- holder -arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections
Loosen fastening points.
1. 5.1 Release fixing clips -1- from cable duct for B+ line -3- .
2. 5.2 Loosen fastening screws -2- of cable duct for B+ line -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening points
Carefully push cable duct for B+ line to one side in order to thread the line beneath it.
Loosen fixing clips -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fixing clips
Loosen fixing clips -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fixing clips
Guide the PDK sub-part outwards, starting from the right.
Detach rubber sleeve -1- under the rear seat.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber sleeve
Release and disconnect electric plug connections on the transmission control unit.
373019 REMOVING AND INSTALLING TRANSMISSION CONTROL UNIT

To do this, fold the carpet at the right forward slightly.
Prepare sub-part for disconnection.
1. 12.1 Unclip fixing clips -1- on the seat well.
2. 12.2 Unwrap insulation in area -2- of the connection for the PDK transmission control unit.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sub-part
Disconnect sub-part in area -X- .

Cut off lines in different lengths (for the shrink-fit hose connections).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sub-part