Installing Main Wire Harness
Information
Check that the lines are routed correctly!
Information
When installing the main cable, take into account the following:
- Make sure that the main line harness is correctly laid.
- Rubber sleeves must be checked for damage and replaced if necessary.
- Always make sure that the rubber sleeve is positioned correctly in the body.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten new fastening nuts for feed-through element at the firewall with > Tightening torque 4.3 Nm (3.1 ftlb.) .
Plug in electric plug connections until they engage securely.