Loosening Main Wire Harness In Right Wheel Housing
NOTE:
Incorrect handling of main wire harness
- Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.
→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.
→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.
- Release and disconnect electric plug connection for airbag sensor.
- Release and disconnect electric plug connection for electric fan.
- Release and disconnect front range control angle sensor electric plug connection.
947819 REMOVING AND INSTALLING FRONT ANGLE SENSOR FOR HEADLIGHT BEAM ADJUSTMENT
- Release and disconnect electric plug connection for pressure switch.
- Remove earth cable on filler neck.
- Release and disconnect electric TPM plug connection).
- Release and disconnect electric desiccator plug connection.
- Release and disconnect electric actuator plug connection.
- Release main wire harness in right wheel housing.
- 9.1 Pull wire harness in the right wheel housing through the spring-strut mount into the plenum panel.