Technical Values: Overview
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Brake disc diameter, front -Turbo S | Diameter | 420 mm | |||
| Brake disc diameter, front -Turbo and GT3 | Diameter | 410 mm | |||
| Brake disc diameter, rear - all | Diameter | 390 mm | |||
| Brake disc thickness, front -Turbo S | Dimension | 40 mm | |||
| Brake disc thickness, front -Turbo and GT3 | Dimension | 36 mm | |||
| Brake disc thickness, rear - all | Dimension | 32 mm | |||
| Front brake pad thickness -Turbo/Turbo S | New | Dimension | 10.17 mm | ||
| Front brake pad thickness - GT3 | New | Dimension | 10.38 mm | ||
| Rear brake pad thickness -Turbo/Turbo S/GT3 | New | Dimension | 11.3 mm | ||
| Check wear dimension of front and rear brake pads | Note wear indicator | Display in instrument cluster | Wear indicator | ||
| Bake disc wear limit, front and rear | Measure using VAS 6813 Tester. Observe measuring prerequisites. New values/wear values and three measuring points are lasered onto the brake disc hub. If the wear value is reached: Replace PCCB brake discs on each axle. |
Measured value | Read off values on the brake disc hub | ||
| Thickness tolerance of brake disc | Maximum | Dimension | 0.01 mm | ||
| Lateral runout of brake disc | Maximum | Measured value | 003 mm | ||
| Lateral runout of wheel hub | Maximum | Dimension | 0.03 mm | ||
| Lateral runout of brake disc when installed | maximum | Dimension | 0.07 mm |