Installing Brake Shoes
WARNING: This page is about a different variant/trim than selected.
WARNING:
Preloaded or pressurized components
- Risk of injury (e.g. crushing or bruising) when removing and installing springs.
→ Do not reach into the danger area.
→ Relieve the tension on components before starting work.
→ Secure components to prevent them from loosening suddenly.
→ Wear protective gloves and goggles.
→ Be very careful when working on the brake system.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Set installation position according to the markings made during removal.
- 1.2 Centre the brake shoes following installation.