Specifications When Handling Oxygen Sensors

WARNING: This page is about a different variant/trim than selected.

NOTE: NOTIFICATION
Incorrect handling of oxygen sensors

Damage to oxygen sensors
Different exhaust emission behaviour
→ Do not remove the plastic cap on the thread until just prior to fitting.

→ Protect oxygen sensors from impact of any kind.

→ Do not kink or twist the cables when screwing in the sensors.

→ Do not re-use dirty or damaged components.

NOTE: NOTIFICATION
Incorrect line routing

Risk of damage to lines and hoses
Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.

→ File down edges and burrs in the routing area or mask them with adhesive tape.

→ Maintain a sufficient distance from components exposed to high temperatures while driving.