Removing Hose Line For Bleeding
WARNING: This page is about a different variant/trim than selected.
NOTE:
NOTIFICATION
Mixing fluids
Mixing fluids
- Risk of damage to components
→ Close off all openings immediately after exposing them (with adhesive tape, suitable stoppers).
Information
- Open connections and lines must be closed off using suitable stoppers or caps.
Information
- O-rings must always be replaced.
- O-rings must be coated lightly with Kluber Syntheso Glep.
- Have a suitable container ready for catching engine oil.
- Remove left hose line for bleeding -1-
.
Unscrew screw -3- .
Loosen clamp -2- and pull off hose line for bleeding -1- .
Replace O-ring.
Hose line for bleeding, left
- Remove right hose line for bleeding -1-
.
Unscrew screw -3- .
Loosen clamp -2- and pull off hose line for bleeding -1- .
Replace O-ring.
Hose line for bleeding, right