Installing Oil Supply Line
WARNING: This page is about a different variant/trim than selected.
Information
- Fit new O-rings on engine oil lines.
- Grease O-rings with a light coating of Kluber Syntheso Glep.
- Remove stoppers before fitting the engine oil lines.
- Installation is performed in reverse order to removal.
Screws securing oil line to cylinder head.
> Tightening torque 10 Nm (7.5 ftlb.)
Screw securing oil lines (pressure side) to turbocharger.
> Tightening torque 10 Nm (7.5 ftlb.)
Screw securing holder for turbocharger lines.
> Tightening torque 10 Nm (7.5 ftlb.)