WM, 2X00IN Battery Trickle Charge: Information

WARNING: This page is about a different variant/trim than selected.

NOTE: NOTIFICATION
Using charging cables/jump lead s directly on the vehicle battery.

Risk of damage to battery sensor
→ Always connect charging cables/jump leads to the external power supply for jump-lead starting.

Information

When working or carrying out tests on the vehicle or when the vehicle is in the workshop, a battery charger with a current rating of at least 90 A must be connected.
As soon as the vehicle is unlocked, e.g. the vehicle is in the workshop or salesroom, it must be trickle-charged using a battery charger.

Remove technical equipment space cover.
852219 REMOVING AND INSTALLING (TECHNICAL EQUIPMENT SPACE) COVER - on "Removing"
First, connect the positive cable from the charger to the positive terminal.
Connect the negative cable from the charger to the ground point for jump-lead starting.
Rear operating instructions for the charger.
Switch off all loads.
Switch on the charger.

Tools and materials

Check battery voltage using a rapid-start battery charger.

See the appropriate Equipment service information,