Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link for anti-roll bar (PDCC) to anti-roll bar (PDCC) | Collar nut, M12 x 1.5/always replace following removal | Initial tightening | 50 Nm (37 ftlb.) | ||
| Connecting link for anti-roll bar (PDCC) to anti-roll bar (PDCC) | Collar nut, M12 x 1.5/always replace following removal | Final tightening | + 50° | ||
| Connecting link for anti-roll bar (PDCC) to PDCC adapter | Collar nut, M12 x 1.5/always replace following removal | Initial tightening | 50 Nm (37 ftlb.) | ||
| Connecting link for anti-roll bar (PDCC) to PDCC adapter | Collar nut, M12 x 1.5/always replace following removal | Final tightening | + 50° | ||
| Pressure line to connecting link | Banjo bolt | Tightening torque | 26 Nm (19 ftlb.) | ||
| Bracket for pressure lines to connecting link | Countersunk screw, M6 x 10 - replace O-ring | Tightening torque | 10 Nm (7.5 ftlb.) |