Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic values | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link (PDCC actuator) to anti-roll bar | Collar nut, M12/always replace following removal | Initial tightening | 50 Nm (36.9 ftlb.) | ||
| Connecting link (PDCC actuator) to anti-roll bar | Collar nut, M12/always replace following removal | Final tightening angle | + 50 (37 ftlb.) ° | ||
| Connecting link (PDCC actuator) to wheel bearing housing | Cheese head bolt M12 x 1.5 x 72 + hexagon nut/replace after each removal | Initial tightening | 50 Nm (36.9 ftlb.) | ||
| Connecting link (PDCC actuator) to wheel bearing housing | Cheese head bolt M12 x 1.5 x 72 + hexagon nut/replace after each removal | Final tightening angle | + 50 (37 ftlb.) ° | ||
| Hydraulic lines to connecting link (PDCC actuator) | Banjo bolt, M12 x 1.5 | Tightening torque | 26 Nm (19.2 ftlb.) |