Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic values | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Strut to body | M12 x 1.5 x 40/always use new bolts following removal | Initial tightening | 70 Nm (51.6 ftlb.) | ||
| Brace to body | M12 x 1.5 x 40/always use new bolts following removal | Final tightening | + 90° | ||
| Strut to mounting for longitudinal arm | Cheese head bolt, M10 x 45 | Tightening torque | 55 Nm (40.6 ftlb.) | ||
| Strut to rear-axle carrier | M12 x 1.5 x 45/always use new bolts following removal | Initial tightening | 30 Nm (22.1 ftlb.) | ||
| Brace to rear-axle carrier | M12 x 1.5 x 45/always use new bolts following removal | Final tightening | + 90° |