LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (21 Exhaust Gas Turbocharging 3.8L (Eng Code MDK.H) -- 992 - 911 CARRERA (992)) >> WM, 213919 Removing And Installing Moulded Hose (On Pressure Side) >> Installing Moulded Hose (On Pressure Side) >> Installing The Moulded Hose (Pressure Side) On The Turbocharger

Installing The Moulded Hose (Pressure Side) On The Turbocharger

WARNING: This page is about a different variant/trim than selected.
  1. Installing -1-  moulded hose.
    G15507419Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Moulded hose on turbocharger

    Coat the inside of the moulded hose -1-  with Kluberplus gel  .

    Position the -1-  moulded hose.

    Tighten screw-type clamps -2-  .

scientia non olet · About LEMON Manuals