Subsequent Work For Diagnostic Scopes
- Connect the Tester to the vehicle and start it.
- Switch on ignition.
- Start diagnostics.
- Select engine electronics (DME) control unit
- Disassembling and assembling only for engine
Maintenance/repairs
Measuring oil level.
- Only for reconditioned engine
Maintenance/repairs
Measuring oil level.
Maintenance/Repairs/Adaptations
Adjust throttle valves.
Only for B6T: Adjust electronic adjuster for turbocharger (bypass flap).
Only for B6T and B4T: Adjust electronic adjuster for turbocharger (VTG).
Maintenance/Repairs/Adaptations
Only for B6T and B4T: Reset oil pressure control adaptation
Reset sender wheel (flywheel) adaptation
Maintenance/repairs
Only for B6T and B6S: Replace injectors.
Perform First start function.
Maintenance/repairs - Working on the high-temperature cooling system
Only for B6T and B4T: Bleed the cooling system.
- Only for short block engine
Maintenance/repairs
Measuring oil level.
Maintenance/Repairs/Adaptations
Only for B6T and B4T: Reset oil pressure control adaptation
Reset sender wheel (flywheel) adaptation
Perform first start.
Maintenance/repairs - Working on the high-temperature cooling system
Only for B6T and B4T: Bleed the cooling system.
- Read out all fault memories, process and delete existing faults if necessary.
- Exit the diagnostic application. End operational readiness on the vehicle. Disconnect the Tester from the vehicle.