Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting rod (conventional) to front stabilizer | Collar nut M10 x 1.5/always replace after removal | Initial tightening | 40 Nm (29.5 ftlb.) |
||
| Connecting rod (conventional) to front stabilizer | Collar nut M10 x 1.5/always replace after removal | Final tightening | + 30° | ||
| Connecting link (conventional) to wheel bearing housing (shock-absorber pipe clamp) | Hexagon nut, M12 x 1.5/always replace following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Connecting link (conventional) to wheel bearing housing (shock-absorber pipe clamp) | Hexagon nut, M12 x 1.5/always replace following removal | Final tightening | + 180° |