Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Flywheel to crankshaft | Internal serration, M10x 1 x 29, micro-self-locking - replace screws | Initial tightening | 60 Nm (44 ftlb.) | ||
| Flywheel to crankshaft | Internal serration, M10x 1 x 29, micro-self-locking - replace screws | Final tightening torque angle | 90° |