Brake Disc Measurement Sheet

A copy or print-out of the data card shown here can be used to document the measured result. The data cards cannot be ordered.

1. Make a copy or print-out of the data card shown here.

   Information 

   • Actual values that are identical in all versions are already entered!
2. Before taking measurements (Test 1 to Test 3), enter the general data, vehicle type and the missing nominal values (new brake disc thickness/brake disc wear limit) in the data card.
3. Carry out measurements (actual status) and enter the values in the data card.
4. If brake discs are to be replaced, carry out Test 2 with the new discs again and enter the latest values in a new data card.

   Brake disc measurement
   Customer:	Rep. Order No.:
   Street:	Porsche VI N:
   City:	Reg. number:
   Telephone:	Date of first registration:
   Vehicle type:	Odometer reading [km/miles
   Checker:	Date/Signature
   Nominal values
   Test 1 = Brake disc thickness
   Brake disc thickness, new [mm]:	Front:	Rear:
   Wear limit [mm]:	Front:	Rear:
   Test 2 = Lateral runout
   Brake disc installed [mm]		max.:
   Wheel hub		max.: 0.02
   Brake disc removed [mm]		max.: 0.03
   Test 3 = Thickness tolerance of brake disc
   Thickness tolerance of brake disc [mm]		max.:
   Measured values (actual values) [mm]	front left front right rear left	rear right
   Test 1 = brake disc thickness (number of measuring points can vary depending on the measuring method)
   Measurement point 1
   Measurement point 2
   Measurement point 3
   Measurement point 4
   Measurement point 5
   Measurement point 6
   Measurement point 7
   Test 2 = Lateral runout
   Brake disc installed
   Wheel hub
   Brake disc removed (difference wheel hub/brake disc installed)
   Test 3 = Thickness tolerance of brake disc (1)
   Thickness tolerance (1)
   (1) Test 3: Do not enter the eight measured values for each brake disc in the data sheet, just comment on the measured result for each brake disc (i.e. OK or not OK)