Installing Radiator

WARNING: This page is about a different car, the 2024 Porsche 911, 2023 Porsche 911, and 2022 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

O-rings must always be replaced.
O-rings must be coated lightly with Kluber Syntheso Glep.

Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws securing holder for electric fan with fan frame to radiator.

> Tightening torque 10 Nm (7.5 ftlb.)

Tighten screw securing condenser to radiator module.

> Tightening torque 5 Nm (3.5 ftlb.)