Connecting The Vehicle Electrical System Battery For Trickle Charging
WARNING: This page is about a different car, the 2024 Porsche 911, 2023 Porsche 911, and 2022 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
If the Gateway control unit is programmed, ensure a charging voltage of 14.0 - 14.2 V at the Gateway control unit. Adjust the charger's voltage if necessary. When programming is complete, reset the charger's voltage.
A suitable battery charger must be connected to the vehicle electrical system when performing the following tasks. All unnecessary electrical loads must be switched off.
When working on the vehicle for more than 15 minutes.
When running diagnostics using the Porsche System Tester.
When adjusting the headlights.
When working on or with the Infotainment system.
If the doors, bonnet and rear lid are open for a long period of time or if these components are actuated frequently.