LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (10 Engine - Crankcase, Suspension 3.0L (Eng Code MDK.Kb) -- 992 - 911 CARRERA (992)) >> WM, 105519 Removing And Installing Oil Separator >> Installing Oil Separator

Installing Oil Separator

WARNING: This page is about a different car, the 2024 Porsche 911, 2023 Porsche 911, and 2022 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove cover for the take-up bores.
  2. Grease new O-rings with Kluber Syntheso Glep (Porsche part number 000.043.204.68).
  3. Install the oil separator.

    Fit oil separator into the bracket for the oil/water heat exchanger.

    Fit and tighten screws.

    > Tightening torque 10 Nm (7.5 ftlb.) 

    Fit vent line on the oil separator and check that it is seated securely.

  4. Metric screws (M6 x 25) can also be used as an alternative to the standard self-tapping screws.

    > Tightening torque 10 Nm (7.5 ftlb.) 

  5. Clip in wiring harness for starter and generator.
scientia non olet · About LEMON Manuals