| High-pressure pump to cylinder head |
Screw, M6 x 20 - replace screws |
Tightening torque |
13 Nm (9.5 ftlb.) |
|
|
| Holder for fuel lines |
Screw, M6 |
Tightening torque |
13 Nm (9.5 ftlb.) |
|
|
| Fuel collection pipe to cylinder head |
Screw, M8 x 80 - observe tightening sequence |
Initial tightening |
10 Nm (7.5 ftlb.) |
|
|
| Fuel collection pipe to cylinder head |
Screw, M8 x 80 - observe tightening sequence |
Final tightening torque angle |
+ 90° |
|
|
| Union nuts for fuel lines |
M14 x 1.5 - coat thread with Microgleit DF977 |
Initial tightening |
8 Nm (6 ftlb.) |
|
|
| Union nuts for fuel lines |
M14 x 1.5 - coat thread with Microgleit DF977 |
Final tightening torque angle |
+ 50° |
+ 10° |
|
| Low-pressure sensor |
M10 x 1 |
Tightening torque |
25 Nm (19 ftlb.) |
|
|
| High-pressure sensor to fuel line |
M10 x 1 |
Tightening torque |
37.5 Nm (27.5 ftlb.) |
+/- 2 Nm (1.5 ftlb.) |
|
| High-pressure sensor to fuel line |
M10 x 1 |
Tightening torque |
37.5 Nm (27.5 ftlb.) |
+/- 2 Nm (1.5 ftlb.) |
|
| Test pressure |
Set on pressure reducer |
Pressure |
8 bar |
+/- 1 bar |
|