Subsequent Work
- Complete the vehicle.
- PIWIS Tester
can now be connected.
Information
- There is no need to create a Vehicle Analysis Log (VAL).
Follow the instructions on the Tester!
- Select DME
in the control unit search screen.
Switch to the Drive links/checks menu item.
Select the Drain tank function.
Activate the Drain tank function by pressing F8=Start.
This takes 30 seconds!
Deactivate by pressing F8=Stop.
- Use the PIWIS Tester
to bleed the high-pressure system using the function.
Refer to the appropriate service information.
- Perform a test drive.