Installing Roof Trim Panel

Information 

Check that the clips are not bent or broken.

Check that all clips are positioned fully and correctly.

Replace damaged or missing clips with new ones.

1. Installation is performed in reverse order.
2. Tighten screws in the front roof trim panel (center) area to > Tightening torque 1 Nm (0.5 ftlb.)  .
3. Tighten screws in the sliding-roof panel area to > Tightening torque 1.5 Nm (1 ftlb.) + 0.1 Nm (0.1 ftlb.)  .
4. Tighten screws on sun visor holder to > Tightening torque 5.5 Nm (4 ftlb.)  .