Installing B-Pillar Trim Panel
WARNING:
Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new fastening screws and nuts following removal.
→ Carry out a visual inspection of all re-used parts.
→ Observe specified tightening torques.
→ Observe specified tightening sequence.
Information
Check that the clips are not bent or broken.
Check that all clips are positioned fully and correctly.
Replace damaged or missing clips with new ones.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten screw to > Tightening torque 50 Nm
. Standard seats
Information
- Guide belt strap from the inside to the outside.
- Ensure that the belt strap can run properly.
- Tighten screw to > Tightening torque 50 Nm . Sports bucket seats