Securing Main Wire Harness In Passenger Compartment At The Left

NOTE: Incorrect handling of main wire harness

Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.

→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.

→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.

Information

Always comply with the regulations for handling ESD-sensitive components!

Always wear approved work clothes and shoes when carrying out assembly work.
Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation.
Do not touch electric pins and plug contacts.

Secure in reverse order. Pay particular attention to the following:
Secure main wire harness in the passenger compartment at the left and lines coming from it at the specified fastening points.

Tighten fastening nut -2- on ground lines to > Tightening torque 8 Nm (6 ftlb.) .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening points

Tighten fastening nut -5- on ground lines to > Tightening torque 8 Nm (6 ftlb.) .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections

Tighten fastening nut -2- on ground lines to > Tightening torque 8 Nm (6 ftlb.) .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fuse box

Tighten fastening nut on fuse box at the left to > Tightening torque 8 Nm (6 ftlb.) .

Plug in electric plug connections until they engage securely.