| Connecting rod (conventional) to front stabilizer |
Collar nut M10 x 1.5/always replace after removal |
Initial tightening |
40 Nm (29.5 ftlb.) |
|
|
| Connecting rod (conventional) to front stabilizer |
Collar nut M10 x 1.5/always replace after removal |
Final tightening |
+ 30° |
|
|
| Connecting link (conventional) to wheel bearing housing (shock-absorber pipe clamp) |
Hexagon nut, M12 x 1.5/always replace following removal |
Initial tightening |
40 Nm (30 ftlb.) |
|
|
| Connecting link (conventional) to wheel bearing housing (shock-absorber pipe clamp) |
Hexagon nut, M12 x 1.5/always replace following removal |
Final tightening |
+ 180° |
|
|