| Connecting link for anti-roll bar (PDCC) to anti-roll bar (PDCC) |
Collar nut, M12 x 1.5/always replace following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link for anti-roll bar (PDCC) to anti-roll bar (PDCC) |
Collar nut, M12 x 1.5/always replace following removal |
Final tightening |
+ 50° |
|
|
| Connecting link for anti-roll bar (PDCC) to PDCC adapter |
Collar nut, M12 x 1.5/always replace following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link for anti-roll bar (PDCC) to PDCC adapter |
Collar nut, M12 x 1.5/always replace following removal |
Final tightening |
+ 50° |
|
|
| Pressure line to connecting link |
Banjo bolt |
Tightening torque |
26 Nm (19 ftlb.) |
|
|
| Bracket for pressure lines to connecting link |
Countersunk screw, M6 x 10 - replace O-ring |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|