Preparing Inner And Outer Rear Cross Member For Installation

Fit in inner rear cross member together with outer rear cross member and secure them to the body.

Drill holes for countersunk blind rivets through both sheetmetal panels with > Diameter 4.1 mm .

2.1 Counter bore the rivet holes with > VAS 6957 - 100° countersink .

G14250691

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear cross member

Remove inner rear cross member together with outer rear cross member.
Prepare marked areas on inner rear cross member for bonding and riveting.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Inner rear cross member
Prepare marked areas on outer rear cross member for bonding and riveting.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Outer rear cross member