Installing Rear Cross Member

Information

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
• Do not begin bonding work until all materials and tool s necessary for later repair work are available.

1. Apply adhesive evenly on the entire bonding surface of the body. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area on inner rear cross member

2. Apply adhesive on inner rear cross member.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Inner rear cross member

3. Rivet in inner rear cross member. > BLIND RIVET PAF.912.884 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Mounting for inner rear cross member

4. Apply adhesive evenly on the entire bonding surface of the body. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Outer rear cross member

5. Apply adhesive on outer rear cross member.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Outer rear cross member

6. Rivet in outer rear cross member. > BLIND RIVET PAF.912.884 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Mounting for outer rear cross member