Installing rear wheel housing (backrest mount) (Coupe)

Information

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
• Do not begin bonding work until all materials and tools necessary for later repair work are available.

1. Install backrest mount and check that it fits perfectly.
2. Remove backrest mount.
3. Apply adhesive on joint areas of the body.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Applying adhesive

4. Apply adhesive on backrest mount.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Applying adhesive

5. Rivet in backrest mount. > BLIND RIVET 999.190.229.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Blind rivets