Preparing Seat-Well Cross Member (Coupe) For Installation

Drill holes for plug-welds on the new seat-well cross member (Coupe) with > Diameter 8.0 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes
Mark and make cut on new seat-well cross member (Coupe) at > Distance 7 mm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seat-well cross member (Coupe)
Fit in middle section of seat-well cross member (Coupe) and secure it to the body.
Drill holes for self-tapping screws -1- through the existing holes using > diameter 4, 0 mm .
> 5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes
Remove middle section of seat-well cross member (Coupe).
Grind down welded seam -1- until the repair sleeve can be pushed in.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seat-well cross member (Coupe)
Prepare marked areas -A- on middle section of seat-well cross member (Coupe) for bonding.
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seat-well cross member (Coupe)
Prepare marked area -B- on middle section of seat-well cross member (Coupe) for applying a full weld using inert gas.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seat-well cross member (Coupe)
Grind down welded seam -1- and prepare marked areas on side section of seat-well cross member (Coupe) for applying a full weld using inert gas.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Side section of seat-well cross member (Coupe)