Removing Front Longitudinal Member (Front Section) (Coupe)

Information 

Before installation, check coding on spare part: Only a front longitudinal member (front section) with a groove -1-  is permitted for installation.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Longitudinal member

Information 

Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

1. Cut front longitudinal member (front section) (Coupe) at-dimension A- 

   Mark and make cut > Distance 392.5 mm 

   Fig 1: Front Longitudinal Member (Front Section) Cutting Dimension (Coupe)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Front side member (front section) (Coupe)

2. Unscrew self-tapping screws -1- 

   > 5X00IN24 SETTING SELF-TAPPING SCREWS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Self-tapping screws

3. Heat bonding area using > V.A.G 1416 - hot-air blower. 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area

4. Remove front side member (front section) (Coupe).