Installing Front Wheel Housing

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Install front wheel housing (outer and inner section) and check that it fits perfectly.
Apply adhesive on the joint area of the body.
Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm

> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection areas

Apply adhesive on front wheel housing (outer section).

3.1 Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm

Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection areas

Rivet in front wheel housing (outer section).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

BLIND RIVETS

A	> BLIND RIVETS 999.190.227.01
B	> BLIND RIVET 999.190.230.01

Apply adhesive on front wheel housing (inner section).

6.1 Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm

Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection areas

Rivet in front wheel housing (inner section).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

BLIND RIVETS

A	> BLIND RIVETS 999.190.227.01
B	> BLIND RIVETS 999.190.229.01