Installing Wing Joining Plate

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Install wing connection panel and check that it fits perfectly.
2. Apply adhesive evenly on the joint area of the body. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Joint area

3. Apply adhesive to the wing connection panel.
   1. 3.1  Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 
   2. 3.2  Also apply an adhesive bead of sealant all around the bonding surface. > Application depth 3 mm 

      > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Joint area

4. Install wing connection panel and rivet in.

   > 5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Wing connection panel

   A	Fit countersunk rivets. > BLIND RIVET PAF.912.885
   B	Set BLIND RIVETS. > BLIND RIVETS 999.190.229.01