Installing Floor Front Section

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Install floor front section and check that it fits perfectly.
2. Apply adhesive on the joint area of the body.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bonding area

3. Apply adhesive on floor front section.

   Apply adhesive evenly over the entire bonding surface. > Application depth 0.5 mm 

   Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Floor front section

4. Rivet in floor front section.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Floor front section

   A	Set BLIND RIVETS > BLIND RIVETS 999.190.227.01
   B	Set BLIND RIVETS > BLIND RIVETS 999.190.227.01

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Floor front section

   A	Set BLIND RIVETS > BLIND RIVETS 999.190.230.01
   B	Set BLIND RIVETS > BLIND RIVETS 999.190.227.01

5. Rivet in floor front section. > BLIND RIVETS 999.190.227.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bore holes

6. Rivet in floor front section. > BLIND RIVETS 999.190.229.01 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Bore holes

7. Weld ground connections

   > 5X00IN10 WELDING ALUMINIUM

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Ground connections