Subsequent Work

1. Install front side member (front section) on both sides.

   > 507955 REPLACING FRONT SIDE MEMBER (FRONT SECTION) 

Subsequent work for body repairs (with straightening system) 

1. Remove vehicle from the straightening system.
2. Clean joint areas and sheetmetal flanges with a wire brush.
3. Prime joint areas and sheetmetal flanges with 2K primer.
4. Restore standard seal with body sealant

   > 5X00IN42 SEAM SEALING

   Also seal the repair area carefully.

5. Paint repair area and adjacent surfaces, if necessary.
6. Restore standard underbody protection with underbody sealant

   > 5X00IN43 UNDERBODY PROTECTION

7. Apply standard cavity preservation

   > 5X00IN44 CAVITY PRESERVATION

   Also carefully apply cavity preservation to the repair area.

8. Install removed accessories in the repair area.