| Brake calliper to wheel bearing housing (basic brake) |
Item 2: Internal serration screw, M12 x 1.5 x 85/always replace screws following removal |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Brake calliper to wheel bearing housing (basic brake) |
Item 2: Internal serration screw, M12 x 1.5 x 85/always replace screws following removal |
Final tightening |
+ 75° |
|
|
| Brake calliper to wheel bearing housing ("S" brake) |
Item 2: Internal serration screw, M12 x 1.5 x 95/always replace screws following removal |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Brake calliper to wheel bearing housing ("S" brake) |
Item 2: Internal serration screw, M12 x 1.5 x 95/always replace screws following removal |
Final tightening |
+ 75° |
|
|
| Brake calliper to wheel bearing housing (PCCB) |
Item 2: Internal serration screw, M12 x 1.5 x 115/always replace screws following removal |
Initial tightening |
30 Nm (22.1 ftlb.) |
|
|
| Brake calliper to wheel bearing housing (PCCB) |
Item 2: Internal serration screw, M12 x 1.5 x 115/always replace screws following removal |
Final tightening |
+ 75° |
|
|