Removing Padding For Front Seat
- Remove backrest cover -2-
.
- 1.1 Unscrew and remove screws -1- .
- 1.2 Unclip backrest cover -2- at the rear -arrow A- .
- 1.3 Guide backrest cover -2- forward and remove it -arrow B- .
Backrest cover
- Passenger's side only:
Unscrew screws -1- and remove ISOFIX -2- .
Screws
- Loosen cover for front seat -3-
at the rear.
- 3.1 Detach rear clamping strip -1- from cover holder -2- (-Arrows- ).
- 3.2 Disengage restraining straps -4- from cover holder -2- .
Rear clamping strip
- Guide cover for front seat -1-
through towards the seat surface -Arrows-
and cut cushion rings -2-
.
Cushion rings
Information
Shown on the left side.
Right side same as left side.
- Unclip cover for front seat -1-
at the sides and fold it over towards the seat surface.
Cover for front seat at the sides
- Press cover for front seat -1-
at the outside with padding for front seat aside -arrow-
and unscrew screw -2-
on the seat shell -3-
.
Cover for front seat
- Unscrew screws -1-
and remove trim panel holder -2-
. Lift up the seat shell to do this.
Screws
Information
Shown on the left side.
Right side same as left side.
- Disengage clamping strip at the sides -1-
and detach cover for front seat -2-
from the seat frame.
Clamping strip at the sides
- Only for vehicles without Adaptive sports seats Plus, 18-way (I-no. Q1J) or Fully electric sports seats, 14-way (I-no. Q2J):
Disengage front clamping strip -1- and detach cover for front seat -2- from the seat frame.
Front clamping strip
- Only for vehicles without Adaptive sports seats Plus, 18-way (I-no. Q1J) or Fully electric sports seats, 14-way (I-no. Q2J):
Unclip cover for front seat -1- from the fixing clips -2- .
Fixing clips
- Only for vehicles with Adaptive sports seats Plus, 18-way (I-no. Q1J) or Fully electric sports seats, 14-way (I-no. Q2J):
Detach padding for seat-surface extension -2- .
- 11.1 Unscrew and remove screws -1- .
- 11.2 Unclip padding for seat-surface extension -3- .
- 11.3 Place padding for seat-surface extension -2- on padding for front seat -arrow- .
Padding for seat-surface extension
- Only for vehicles with Adaptive sports seats Plus, 18-way (I-no. Q1J) or Fully electric sports seats, 14-way (I-no. Q2J):
Unclip seat cover -1- from the fixing clips -2- .
Fixing clips
- Only for vehicles with heated seats (I-no. 4A3) and Adaptive sports seats Plus, 18-way (I-no. Q1J) or Fully electric sports seats, 14-way (I-no. Q2J):
Release and disconnect electric plug connection for seat-surface extension -1- and guide it out of the clip for the seat cover -2- .
Electric plug connection
- Only for vehicles with heated seats (I-no. 4A3):
Disconnect electric wire harness for seat heating.
- 14.1 Release and disconnect electric plug connection for seat heating -1-
.
Information
Make sure not to trap or damage the wire harness when pulling it through.
- 14.2 Guide electric wire harness out through the seat frame -arrow- .
Electric plug connection
- 14.1 Release and disconnect electric plug connection for seat heating -1-
.
- Remove padding for front seat.