Installing Trim Panel

Information 

Check that the clips are not bent or broken.

Check that all clips are positioned fully and correctly.

Replace damaged or missing clips with new ones.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Secure rear trim panel by tightening screw -1-  to > Tightening torque 3 Nm (2.2 ftlb.) +/- 0.5 Nm (0.4 ftlb.)  .

   Secure front trim panel by tightening screw -1-  to > Tightening torque 3.5 Nm (2.4 ftlb.) +/- 0.5 Nm (0.4 ftlb.)  .