LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 66 Exterior Equipment -- 992 - 911 CARRERA (992) >> WM, 668919 Removing And Installing Rear-View Mirror >> Installing Rear-View Mirror

Installing Rear-View Mirror

  1. Position rear-view mirror.
    1. 1.1  Tie cord to the wire harness.
    2. 1.2  Pull wire harness for rear-view mirror partially into the door using the cord.
    3. 1.3  Position rear-view mirror in the door aperture.
    4. 1.4  Pull wire harness for rear-view mirror fully into the door using the cord.
    5. 1.5  Detach the cord.
    6. 1.6  Position rubber seal for wire harness in the opening.
    7. 1.7  Check that the rubber seal is seated correctly.
  2. Tighten screw on rear-view mirror to the tightening torque > Tightening torque 23 Nm (17 ftlb.)  .

    Information 

    The adhesive pad cannot be pulled off without damaging it and must always be replaced.

  3. Stick new adhesive pad on firmly.
    1. 3.1  Position adhesive pad so that the assembly opening is completely covered.
    2. 3.2  Press adhesive pad on firmly.
scientia non olet · About LEMON Manuals