Installing Rear Apron
NOTE:
NOTIFICATION
Heat protection panels not fitted correctly
Heat protection panels not fitted correctly
- Risk of damage to adjacent parts
→ Make sure the heat protection panels overlap correctly.
→ Replace damaged or deformed heat protection panels.
→ Check heat protection panels for deformation, secure fixing of the aluminum braided cord, cracks and missing or damaged fixing tabs.
→ At least 80% of the total sealing area must be sealed without gaps.
Information
Get another person to help you to install the rear apron.
- Installation is performed in reverse order.
- Tighten top screws to > Tightening torque 3.2 Nm (2.4 ftlb.) .
- Tighten bottom screws to > Tightening torque 3.2 Nm (2.4 ftlb.) .
- Tighten screw to > Tightening torque 7 Nm (5.2 ftlb.) .
- Tighten screws to > Tightening torque 3.2 Nm (2.4 ftlb.) .
- Tighten nut on wheel housing liner to > Tightening torque 2.5 Nm (1.75 ftlb.) + 10 % - 15 % .