LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> 911 Targa 4 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 63 - Bumpers - 911 CARRERA (992) >> WM, 637319 Removing And Installing Rear Bracket >> Removing Rear Bracket

Removing Rear Bracket

  1. Unclip cable plug -1-  for Lane Change Assist control unit.
    1. 1.1  Loosen cable clips -2-  on the bracket.
      Fig 1: Rear Bracket Component Location
      G14263951Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Cable plug and cable clips on supply lead for Lane Change Assist control unit 

  2. Loosen wiring harness for oxygen sensor and screw for heat shield.
    1. 2.1  Unclip plug connection -1-  from holder -2-  and disconnect plug connection.
    2. 2.2  Unclip wiring harness at the bracket -3-  .
    3. 2.3  Unscrew tapping screw -4-  for heat shield.
      G14263952Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Wiring harness for oxygen sensor on bracket 

  3. Remove cover -1-  for top bracket.
    1. 3.1  Unscrew tapping screws -2-  and remove cover.
      G14263953Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Cover on bracket 

  4. Unscrew screws on the rear bracket -1-  and on the lower heat shield -2-  .
    G14263954Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for rear and lower retaining frame 

  5. Loosen rear bracket.
    1. 5.1  Unscrew collar nuts -1-  on the retaining frame and remove sheetmetal clips -2-  .
    2. 5.2  Unscrew tapping screws -3-  for lower heat shield.
      G14263955Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Side mounting for rear bracket 

  6. Remove bracket and pull off air guide -1- (-Arrows-  ).
    G14263956Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Air guide for charge-air cooling 

scientia non olet · About LEMON Manuals